flexi starter | CutterPros

Bigg Dawgg Graffix Racing Decal Cut On A ProCut Contour 4800 Using InkScape And Flexi Starter

By Brian
March 19, 2013
No Comments

As a continuation of the post “Font Cleanup Before Sending Artwork To A Vinyl Cutter“, Dan submitted the final result of his race car graphics for Bigg Dawgg Graffix. See picture below. This was produced … Continue Reading →

Sending InkScape Files To Flexi To Cut Artwork On A Vinyl Cutter

By Brian
March 13, 2013
No Comments

Although InkScape can produce many file types and Flexi can read in many file types, Flexi cannot read in InkScape native files directly. InkScape native files are SVG (Scalable Vector Graphic) files. The most consistently … Continue Reading →

Artwork Quality Hidden Objects And A Vinyl Cutter

By Brian
March 10, 2013
No Comments

I had the pleasure of assisting Dan today and yesterday as he was doing offsets in InkScape to create vinyl overlaid numbers for his racecar. When we went to cut out the numbers we ran … Continue Reading →

Contour Cutting In Flexi Starter 10

By Brian
February 25, 2013
No Comments

Following are the steps for contour cutting graphics in Flexi Starter 10. This references the CutterPros technical brief found here: http://support.cutterpros.com/downloads/Contour-Cut-Tutorial-ProCut-Contour-Cutter-Flexi-Starter-10-08-05-12.pdf First, you must calibrate your cutter for the offsets that Flexi uses as the … Continue Reading →